How To Remove A Swirled Ceiling
Things Needed
-
Plastic covering
-
Painter's tape
-
Spray bottle or garden mister
-
Trowel
-
Wire brush
-
Drywall texture compound
Tip
When you are through, take the plastic off the walls first and then roll the material in toward the center of the room. This will keep spills to a minimum. After you are done, you need to recover drywall seams with compound and drywall tape before painting.
Not all homeowners desire textured ceilings. If you have a swirled texture ceiling and would prefer a simple, plain surface or a different texture, then you must first remove the material from the drywall. The texturing material consists of a drywall compound mixed with sand or another material, and it is removable, although it takes some work. This is a messy process that requires drop cloths to protect other surfaces.
Step 1
Turn the power off to the room by flipping the switch in the breaker box.
Step 2
Use a screwdriver to remove the light fixtures from the ceiling. Untwist the wires and set the fixtures aside. Ball up some plastic, such as a shopping bag, and push it into the light fixture hole to protect the wires from moisture.
Step 3
Place plastic sheets down over the floor and tape them to the wall edges with painter's tape.
Step 4
Tape more plastic sheets to the walls and cover them all the way to the floor. Tape the wall sheets to the floor sheets to completely seal all surfaces except the ceiling.
Step 5
Fill a spray bottle or garden mister with water. Spray the ceiling in a small 3-foot section to moisten the surface. You want the ceiling damp, but not soggy.
Step 6
Scrape the ceiling with a small trowel or taping knife. Use a blade with rounded corners so that you do not gouge the drywall. Continue scraping until the 3-foot section is virtually free of texture. Repeat with other 3-foot sections until the ceiling is clean.
Step 7
Cover the floor with a second layer of plastic and go over the entire ceiling again to remove any remaining texture.